This product is formulated for use on Ceramic tiled floors that have not been sealed. It creates an invisible tread on tiles that significantly increases the slip resistance providing the treated surface with a safe & efficient grip. This treatment significantly reduces the problem of dangerous surfaces in wet conditions and lasts up to 3 years. https://slipnomore.com/

This product can only be used on Ceramic tiles that have not been sealed

Application Instructions
1. Clean the area to be treated thoroughly with Slip No More Cleaner & Maintainer using a mop. For very dirty or weathered floors, use a hard bristle broom to remove dirt.
2. Shake well before use (make sure there is no sediment at the bottom of bottle)
3. Pour product into pressure sprayer and build up pressure by pumping the handle
4. Spray the product evenly over the area with a pressure sprayer. (Always rinse the pressure sprayer thoroughly after use). Ensure that you cover the floor well and do not spray further than you can see. DO NOT let the product dry on the floor
5. Leave the product on the surface for the recommended time:
- Glazed Ceramics 2-8min based on performing a test patch first.
6. Neutralize by applying Slip No More Neutralizer over the treatment in the same format as the treatment was applied with a separate pressure sprayer.
7. Rinse thoroughly with water.
8. Dry area and wash away any excess residue.
9. For optimum results, maintain with Slip No More Cleaner & Degreaser.


Important Notes
• ALWAYS perform a small test first in order to determine the treatment time that is required to treat the entire floor. We suggest applying the treatment as per the instructions on a single tile in an out of sight area. If you do not achieve the required amount of grip within the prescribed time, repeat the treatment in 1-minute increments until you have achieved a satisfactory result.
• When working with cleaning products and chemical treatments, always wear the necessary safety protection. We suggest using nitrile gloves and gumboots at a minimum when working with our products.
• Should the treatment come into contact with your skin, rinse immediately with loads of water
• Never let the treatment dry. Treat smaller areas on windy or extremely hot days.
• For more information please view our application training videos on YouTube or contact our offices for technical advice www.slipnomore.co.za +27 10 595 9663
• When working with Slip Prevention Cleaning Products, Anti-Slip Chemical Treatments, Non-Slip Coatings, Adhesives, and Power Tools always wear the necessary safety protection. We suggest, as a minimum, using nitrile gloves when working with any of our products.
• In the event of accident or spillage, refer to the safety data sheet.
• Always rinse the floor with clean water after use after any Anti-Slip or Non-Slip applications.
• Always rinse equipment and tools after use.
• Please respect the environment and dispose of Non-Slip Product packaging responsibly.