Join us on this magical journey of excitement as we show you step-by-step how to install the Ironman 4x4 Raid Rear Bumper on your 6th-Gen 2021+ Ford Bronco.

Get your Ironman 4x4 Raid Rear Bumper for your 6th-Gen Ford Bronco here: http://ironman4x4america.com/raid-rea...

Chapter Selection:

0:00 Intro
0:27 Remove spare tire
0:39 Unplug rear bumper wire harness
1:20 Remove factory rear bumper
2:16 Remove parking sensor harness from factory bumper
3:03 Mark sensors with a paint pen to indicate passenger or driver side
3:30 Remove parking sensors
5:18 Remove license plate light from factory bumper
5:43 Install Ironman 4x4 light pods into Raid bumper
5:54 Install parking sensors to Raid bumper
8:36 Explanation for wire harness extensions
8:54 Cable management
9:06 Plug rear license plate light harness into original factory harness
9:51 Install gravel guard plates for Ironman 4x4 light pods and parking sensors
11:01 Place chassis reinforcement brackets in frame
11:45 Install Raid bumper shell and recovery points
13:48 Route your license plate light relocate wire harness
17:51 Remove inner panels from rear door
18:34 Zip tie license plate light wire harness to follow factory rear camera harness
19:15 Feed license plate wire harness through rubber grommet pass through
21:54 Re-install spare tire with lug extensions
22:50 Feed wire harness through spare tire to connect to license plate light and relocate bracket
23:33 Install license plate relocate bracket to spare tire lug extensions
24:05 Insert spring clips into license plate relocate bracket and install license plate
24:24 Re-install inner panels on the rear door
24:43 Reconnect bumper wire harness
25:04 Conclusion

For additional installation support or if you have any questions please reach out to our customer service team. https://ironman4x4america.com/​