In this video I'm going to show you how to configure your slicer settings to get the most out your 3d prints when using the Creality Sonic Pad.
You may have already tried printing something that you've sliced without any of these changes and found that the quality is good and that is very likely. However, as we go a little further and start to ramp up the speed, you may start to see issues.


Creality Profiles Download:
https://www.creality.com/pages/downlo...

Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)

*Creality Sonic Pad*
UK: https://www.geekbuying.com/go/7TPdqKOx
US: https://www.geekbuying.com/go/7TPdvEYU
Everywhere else: https://www.geekbuying.com/go/7TPawLUl

Discount Code: NNNCRESONPAD

Amazon
https://amzn.to/3AiYtwD
Discount code: 10NTDPJE

*Other Sonic Pad Videos*

Sonic Pad Review:    • Creality Sonic Pad - The Easy Klipper...  

Sonic Pad Basic Series
Part 1 - Connecting to a Creality 3D Printer:    • How To Connect A Creality 3D Printer ...  
Part 1a - Connecting to a non-Creality 3D Printer:    • How To Connect A Non-Creality 3D Prin...  
Part 2 - Completing initial setup:    • Completing The Initial Setup Of The S...  
Part 3 - Starting a print and UI Tour:    • Starting A Print With A Sonic Pad And...  
Part 4 - Controlling remotely and WEB UI:    • How To Control Your Sonic Pad Remotel...  
Part 5 - Connecting a camera and tinelapse videos:    • How To Connect  A Camera To Your Soni...  

Sonic Pad Intermediate Series
Part 1 - PID Tune    • How To PID Tune With The Sonic Pad - ...  
Part 2 - E-Steps/Rotational Distance    • How To Tune E-Steps/Rotational Distan...  
Part 3 - Slicer Settings    • Slicer Settings and Profiles With Cur...  
Part 4 - Sending Prints From Slicer/Images On Screen    • How to Send Files To Your Sonic Pad A...  
Part 5 - Input Shaping -    • Tune Input Shaping With The Included ...  
Part 6 - Pressure Advance -    • Video  
Part 7 - MACROs -    • Video  
Part 8 - Max Acceleration -    • Maximum Acceleration Test (How Fast C...  
Part 9 - Mid-print Filament Change -    • How To Complete a Mid-Print Filament ...  

Other
Firmware Update September '23 -    • Creality Sonic Pad Firmware Update - ...  
Creality Sonic Pad - How To Update Firmware Without Losing Everything! -    • Creality Sonic Pad - How To Update Fi...  


..............................................................................................................................................................

BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.

https://www.buymeacoffee.com/rickyimpey

You can also use the YouTube 'Thanks' button above if you prefer.
...............................................................................................................................................................