In this video, I explain the best method that I've found for removing the dross from plasma cut parts. This applies to both hand cut parts and cnc plasma cut parts. The technical term for the material left behind after plasma cutting is dross, but most of us use the term slag, probably because it sounds cooler LOL.

Here are some links to the products mentioned in the video:

Magnetic Chuck for holding steel parts: https://amzn.to/44GoZNy

Air Chisel: https://amzn.to/3OeZCgC

Air Pressure Regulator: https://amzn.to/3Q3MJaa

Angle Grinder: https://amzn.to/3DjAsa1

Flap Discs: https://amzn.to/4716pBZ

Hearing Protection: https://amzn.to/3DcRBSV

Thank you for using the links provided above, these are Amazon Associate Links and I will earn a small commission should you purchase anything using them. Thanks again!