► Brake Fluid Flush and Bleed on my 2002, UK spec 1.8T Audi TT (225 BAM) using a Sealey VS0205 Automatic Brake and Clutch Bleeder

ATE Brake Fluid: http://ebay.eu/2gQ4yFx
Sealey Auto Bleed: http://amzn.to/2h06Ghg

Bentley Manual Sequence:

1 - Left front brake caliper

2 - Right front brake caliper

3 - Left rear brake caliper

4 - Right rear brake caliper

Leave bleeder screw open, with bleeder bottle hose connected, until brake fluid emerges out of the bleeder screw clear and free from air bubbles.

Build up pressure in brake system to aid bleeding by pumping pedal five times.

Tighten bleeder screw to 10 Nm. Detach hose and install protective cap on bleeder screw.

Repeat procedure on remaining brake calipers in the specified bleeding sequence.

Top off fluid level in reservoir to "MAX" mark (according to degree of pad wear) and close reservoir cap.

Start engine and check brake pedal travel and pressure.

If the pedal travel is excessive, check brake system for leaks or repeat bleeding procedure.

If you have any questions, I will try my best to answer them!

►Twitter -   / willbaroo  
►Instagram -   / willbaroo  
►Snapchat - willbaroo
►Email - [email protected]
►Website: http://www.will-belcher.co.uk