In this video, I demonstrate how I DIY hardwired my EV Charger (Electric Vehicle Supply Equipment or EVSE). There is a lot of information in this video, more than just the charger installation steps. I show you my tips and tricks throughout the project, how to get through challenges when things don’t go as planned, and how to build a PVC board box to protect the charging cord if you are mounting your charger between two garage doors. I also talk about what my preferred amperage to charge at is, so make sure you catch that at the end of this video. Please read the ***electrical disclaimer below, and understand it’s very dangerous working in your attic. One wrong step, and you will fall through your ceiling.

Please LIKE and SUBSCRIBE if you enjoyed this video to help my channel grow.

CHECK OUT my “EV Charging Cord Protector for Under Garage Door Charging” video here:    • How To Run Your EV Charging Cord Unde...  

For any questions email me at: [email protected]

***Electrical disclaimer:
It is important to note that any electrical work should be performed by a licensed professional. The information provided in this Home DIY channel is for educational purposes only, and is not intended to replace professional advice. The channel owners and contributors cannot be held responsible for any damages, injuries, or losses that may result from use or misuse of the information provided. Viewers should always use their own discretion and consult with a licensed electrician before attempting any electrical work. Also, in most cases, you will need to pull an electrical permit to install a new EV charging circuit. Rules can differ from one city or municipality to another.