I am rebuilding a Puch ZA50 moped engine. Do dont need too many special tools but I do recomend a hand impact driver. I like this one since it has long bits - https://amzn.to/45uoRAF .

Feeling generous? Buy me a coffee to help support my videos.
https://www.buymeacoffee.com/Cornped

Flywheel puller - https://amzn.to/3PRcBEI
Impact Driver - https://amzn.to/45uoRAF
Gear puller - https://amzn.to/3Qnc1jG

Great wiki - https://www.mopedarmy.com/wiki/ZA50

Crank Bearings
L17 (Magneto side)
E20 (Transmission side. Do not mistakingly use B20)

Transmission Cover Bearings
6002 (Clutch Bell/Crank)
16101 (Main Shaft, Oil Injected)
16100 (Main Shaft, Non Oil Injected)

Main Shaft Case Bearing
6005

Output Shaft Bearings
B-810
6203

Seals
17x35x(7 or 8mm) Magneto side crank seal
20x35x(7 or 8mm) Transmission side crank seal
25x35x(7 or 8mm) Output shaft seal — stock seal comes with a metal ring. Pop that out if you're going to replace it.


#Puch #ZA50 #mopeds

Gear Links
Main Camera https://amzn.to/3qw1Cnt
Main Lens https://amzn.to/3qsSOPf
Wide Lens https://amzn.to/3pwmOdQ
Portrait lens https://amzn.to/32ooNbv
Mic https://amzn.to/3HgkBch
Light https://amzn.to/3qw2SXJ
360 Camera https://amzn.to/3euCkjV
Selfie stick https://amzn.to/3pxJGJK