I built this DIY storage table (bar height) for my overlanding adventures. I needed to get a system that was better than bins from Home Depot. So, I made this out of 1x3’s and Front Runner Wolf Pack Boxes. This may look insane, but for me it is an EPIC storage solution! This will get your gear up, and off the ground. This is especially awesome if you have a Jeep and you sleep in it while car camping. Let me know if you have any questions in the comments. (Episode 25 - 12/11/22)

LEGS:
1”x3”x4’ = need 4 of them

SUPPORTS UNDER BOXES:
1”x3”x40” = need 2 of them (as shown), but go go up to 53” if desired.

PAINT
2 cans of black spray paint
2 cans of clear protectant spray paint

HARDWARE:
12 washers, suggest large
12 screws approx. 1 1/8” long (Just make sure that they fit tightly through the washers and that they are not so long that they go all the way through the supports under the boxes. Do not over tighten, you could crack bottom of box.)

CARRY CASE:
1 old sock, or two (One for each end 😂)