In this video, I walk through the install, assembly, and Klipper configuration for the Voron 0 Display. My goal with this video is to provide all the steps in a relatively concise format from start to finish. This is a pretty straightforward upgrade, and I'd guesstimate you could do it in about an hour (or even less) once you have the parts printed. Cutting and crimping a USB cable adds time, but I think it's worth the effort and will give you the cleanest install.

Correction: The self tapping screws needed are 12mm, not 8mm. I didn't end up using them, and they are hard to source- so I'd say don't bother with them.

Special thanks to Steve Builds as well- I watched his Live Stream and took away a few ideas (like the JST-XH). I encourage you to check his video out for additional info.
   • Quick Build: V0 Display  

Scroll down to jump to specific areas:

0:36 - Walkthrough of Display Screen Features
2:48 - Parts Required
4:21 - Note about Heat Inserts
7:03 - Using a JST-XH for a clean install
7:50 - Installing heat Inserts
9:00 - Assembly of Screen into 3d Printed Parts
10:03 - Cutting a USB cable and crimping JST-XH connectors
15:06 - Powering up
15:12 - Getting device DFU ID
15:55 - Compiling Klipper
16:56 - Flashing Klipper to Voron 0 Display
17:20 - Confirming Klipper flashed
17:33 - Downloading DisplayEncoder.cfg from Github, and Uploading to Mainsail
18:17 - Adding an include line in Printer.cfg for DisplayEncoder.cfg
18:47 - Finishing up the install
19:57 - Summary and Conclusion

Main link to Voron 0 Display Github. You can find the STL's, Assembly Information, config file, etc. all from the Github. Scroll down for specific links as well.
https://github.com/VoronDesign/Voron-...

Direct Link to Klipper Install and Flashing Guide:
https://github.com/VoronDesign/Voron-...

Direct Link to STL's. I printed the knob, housing front, housing rear, (no usb option) and the single piece mount in the v0.1 folder.
https://github.com/VoronDesign/Voron-...

Direct link to DisplayEncoder.cfg:
https://github.com/VoronDesign/Voron-...

Where to buy?
Because of the chip shortage, it may be hard to find/source a display. Here are a few links to check.

I purchased mine here: https://www.fabreeko.com/products/ldo...
DeepFriedHero: https://deepfriedhero.in/products/vor...
Aliexpress: https://www.aliexpress.com/w/wholesal...
Printed Solid: https://www.printedsolid.com/products...

Example kit for the JST XH connectors needed:
https://www.aliexpress.com/item/40001...

Tools featured in my video are linked below. These are Amazon Affiliate Links. If you are considering buying a tool, please use my link- it costs you nothing extra, and helps me out. As an Amazon Associate I earn from qualifying purchases. Thanks for your support!

Engineer PA-09 Crimpers - https://amzn.to/3aLgZB9
Hakko 888FX High Quality Soldering Iron - https://amzn.to/3FZtsiM
Heat Insert Tips - https://amzn.to/3aLh6N5
Capri Wire Strippers - https://amzn.to/3ctPY62

Quick Reddit Post that is helpful on customizing the display menus::
  / changing_lcd_menu_layout_in_klipper