G'day everyone,

I wasn't planning on making this project, but since I recently built the whet sander, I thought that it was about time that I make a cover for the bench grinder wheel. It rusted out years ago and I have been meaning to make a replacement.

The cover is quite simple, except that it relies on a rolled piece of steel to act as the frame. I need a ring roller to make it.

I didn't want to spend a whole lot of time or materials on this project because I don't see it being used a whole lot in the future, so I opted to make it from the mild steel plate that I have left over from the whet sander project.

#machining #diy

Timestamps
0:00 - Intro
1:11 - Making the frame
8:22 - Making The Connector Pins
12:02 - Clamping Screw
14:00 - Making The rollers
17:33 - Final Test