I've always been a fan of mounting splitters/lips securely, and not using any double sided tape so they can be put on/removed easily. Here's how I mounted a GTS style splitter on my M2C and made it durable enough for the track (seriously, I can completely stand on the splitter and it holds up just fine).

Even though I filmed this with the bumper off, the backing plates, rivnuts, and splitter can be installed with the bumper on the car. It's just a bit more difficult working upside down!

Index:
0:00 Intro
0:15 Aligning splitter and bumper
0:52 Intro to rivnuts
2:44 Installing backing plates and rivnuts
8:07 Adding thread clips for the sides
9:31 Adding holes to the splitter
10:49 Splitter skid protection
11:14 Completed installation

-Ahacarbon/JC Sportline GTS Splitter: https://tinyurl.com/M2CGTSSplitter
-Rivnuts (I used the 10-24 ones here): https://www.mcmaster.com/rivets/rivet...
-#10-24 x 3/4" Bolts: https://www.mcmaster.com/screws/hex-h...
-#10 washers: https://www.mcmaster.com/standard-was...

*Affiliated Links:
-Rivnut Tool: https://amzn.to/3zyNEVT
-Trigger Clamps: https://amzn.to/3K0uIo7
-Stepped Drill Bit Set: https://amzn.to/3HJDpAW
-U-Clip Set: https://amzn.to/3akVTu6
-Sliplo Scrape Protection: https://amzn.to/3f20DWG

____________________________________________________
DISCLOSURE:
Some of the product links on this page are Amazon affiliated so I earn a commission at no extra cost to you. Thanks for your support!