Published On Aug 25, 2023
Making a plasma torch table inspired from other makes.
I decided to start from scratch on some of the items because I wanted to make them out of metal and try to go as compact and simple as possible. If this works well, Ill be making a full size table using some of the same components.
These are the items that I used. So far holding up great!
Controller
https://dcmotive.com/products/p/6-axi...
The air filter regulator dryer
https://amzn.to/49FabkF
The e-stop button
https://amzn.to/3I8Oa1Y
The 6mm proximity switches
https://amzn.to/3whRrta
The Plasma cutter
https://amzn.to/48odlZd
The Plasma pencil torch (was PTM60, may be out of stock)
https://amzn.to/49Eztzw
The 24vdc power supply
https://amzn.to/3OS2XSq
The enclosure box
https://amzn.to/3uJPRQr
The water pan
https://amzn.to/3OPyTaa
The locking casters
https://amzn.to/4bJFSeu
Just so you know as an Amazon Associate I earn from qualifying purchases, and I super appreciate the spare change it brings. I only recommend items that I use and would buy again myself.