We installed a set of Morimoto 4Bangers on our Z1 Off-Road Ditch Light Brackets.
In this video you'll see how to install the brackets and lights, as well as how we ran the wiring for these.
We used the Morimoto wiring harness, and a factory Nissan Titan switch, so you'll also see how to remove the switch blank on a Titan (A61) for using an OEM style switch.
This is a great setup for adding more light to the shoulders and ditches as you're tackling your next adventure.

Get your 2016+ Titan Ditch Light Brackets Here:
https://www.z1offroad.com/z1-products...

Z1 Brackets with Morimoto 4Banger Lights: (As shown in video)
https://www.z1offroad.com/hood/z1-off...

Check out all Z1 Off-Road Lighting Offerings Here:
https://www.z1offroad.com/exterior/li...

0:00 - Intro

0:12 - What You'll Need
- Tools and products you'll need to install the brackets on your truck.

0:24 - Unbolting the Hood Hinge Hardware
- Removing hood hardware on the Nissan Titan

1:10 - Installing the Brackets
- Step-by-step of bolting up the brackets.

1:51 - Round 2
- Installing the passenger side bracket.

2:15 - Installing the Ditch Lights
- Bolting up the Morimoto 4Banger lights on the Z1 Brackets.

2:46 - Wiring the Ditch Lights
- How to wire the ditch lights on your Nissan Titan

3:34 - Routing Wire through the Firewall
- Where we chose to run the wiring harness from the switch, batteries and to the lights.

4:15 - Installing a Switch in Factory Switch Blank
- Hooking up the wiring harness to an OEM Titan switch.

4:57 - Removing Nissan Titan Switch Blank
-How to pop out and remove the factory switch block off.

6:22 - Routing the Wiring Harness through Engine Bay
- Where we chose to run the wires to keep them free from heat sources, moving parts, and keep a clean install.

7:49 - Connecting to The Ditch Lights
- Routing the wires through the dash cowl and to the ditch lights.

8:44 - Overview