I tried to make a thin rip push stick for my table saw based on an old design in an out of print magazine. It did not go well. But I think I fixed it and made it much safer to use. Check it out! Amazon and other affiliate links are used in this description and they help support this channel.

Videos To Watch Next
How to Make a Table Saw Sled -    • How to Make a Table Saw Sled with Han...  
How to Build a Miter Station -    • How to Build a Space Saving Miter Saw...  

Build Plans: https://www.731woodworks.com/store
Greatest Free Gift: http://story4.us/731Woodworks

Products I Use and Recommend
MicroJig Gripper - https://lddy.no/1cj2c
Use code 731MICROJIG10 to save 10% Off
Table Saw Blade I Use https://lddy.no/1cj2e
Use code 731CMT10 to save 10% on CMT Blades
Outlaw's Board Butter - https://www.731woodworks.com/store/bo...
Blaster Dry Lube for Table Saw - https://amzn.to/3pwFF7C
Little Red Delve Square - https://amzn.to/3T4FwpG
Favorite Tape Measure - https://amzn.to/3A9jnxF
My Table Saw - https://amzn.to/3T6J9LU
My Bandsaw - https://amzn.to/3K8ZATv

Join this channels membership to get access to exclusive member only livestreams, discounts, and other perks:
   / @731woodworks  

You can support us on Patreon as well   / 731woodworks  

I get my stickers from Sticker Mule: https://www.stickermule.com/unlock?re...