Published On Aug 1, 2020
This video shows the way I paint areas that I have engraved using my GlowForge machine. Also a little preview of future videos on how to prep your boards, spray painting and laying transfer paper! Enjoy!
I used 1/8in birch wood for this project.
Transfer paper: https://bit.ly/3fM0rsP
Spray Paint: https://thd.co/3ium6r3
Squeegee I use: https://bit.ly/3gN5xpM
Sander: https://thd.co/30HX4Pd
Sanding Discs: https://low.es/2F3OMbU
Duct Tape: https://amzn.to/3gNQP1P
Glowforge---Use this link and get up to $500 off --- https://glowforge.us/r/DEUEUWLB
I'm always available to chat about my process! Its not the only process out there, but its the best one for me!
[email protected]
craftfit17.com
@craftfit17