Howdy folks! This video gives a closer look at my homemade air conditioner ladder hoist or crane. It has served me well in lifting several ac units onto roofs. Below you can find the link to the electric hoist that I used for this setup. I only spent a total of 120 dollars for this tool! If you found this video helpful, leave it a like and consider subscribing to the channel for more DIY hvac content! Cheers all

Electric 110v hoist: https://amzn.to/3R7caoY


And here are all my go to tools for working in the HVAC field that I highly recommend!

Gauges: https://amzn.to/3NRqvnf

Pipe cutter: https://amzn.to/3OXbjXe

Hard start kit: https://amzn.to/3yqjzI7

Pipe cutter: https://amzn.to/3OXbjXe

Milwaukee right angle drill: https://amzn.to/3RkM6Yb

Nut Driver bit LONG 5/16 & 1/4: https://amzn.to/3OXoveo

Nut Driver bit SHORT 5/16 & 1/4: https://amzn.to/3z1MJPr

Malco Turbo Shears: https://amzn.to/3amb493

Best Foil Tape for duct work: https://amzn.to/3ACiFuW

Duct Sealant: https://amzn.to/3IEXcDD

Pipe swagging tool used in the end of video: https://amzn.to/3c1vPHu

Oxygen & Acetylene Starter kit: https://amzn.to/3bTLt7z

Nitrogen Flow Tool: https://amzn.to/3Rp0tur

Brazing Rods: https://amzn.to/3AxJSid

5cfm Robinair Vacuum pump: https://amzn.to/3Ipt7Yh

Pipe cutter: https://amzn.to/3OXbjXe

Pipe swagging tool used in the end of video: https://amzn.to/3c1vPHu

Milwaukee Surge impact gun: https://amzn.to/38z9i3u



These links are connected with my amazon affiliates account so I get a small percentage if these links are used. Thanks so much for your support!

⚠️ Disclaimer:
This video is for educational purposes. Any and all HVAC repair work is done at your own risk. The DIY HVAC Guy channel is not responsible for any possible damages or injuries caused by the use or misuse of the provided information.