All the materials and tools i used to make both jigs here are simple.(for welding and blade grinding)
They look like all these that are out there,but with a few "tweaks" and ideas that i came up with.They are not fancy but,
the final designs are mine and i also took a lot of information from the net, magazine and books.
References were taken also from :
Fine Woodworking magazine No40 year 1983.This article was compiled from information contributed by
three woodworkers: Wash Adams, from Richardson, Tex. ;
Doug Polette, a professor a t Montana State University in
Bozeman; and John Leeke, of Sanford, Maine.
for welding:
1)map gas
2)brass rod braze 3mm (you can get thinner if you can i just hammered it to make it thin.)
3)Borax (cleaning white powder which hepls for surface preparation)

Finaly please dont get disappointed from first welds and go ahead and make 5-10 weldings from a scrap blade.YOU WILL SUCCEED.
If i did it ,you can too!