Learn how to install the Graco Turn2Me 3-in-1 Car Seat forward-facing using the LATCH system by following these easy steps. Before learning how to install your car seat, you will need to know how to use the car seats’ turn feature. The turn levers are located under each armrest, but you only need to use one to turn the seat. At the same time, squeeze the blue trigger and the grey lever and rotate the car seat. After rotating your infant car seat into the forward-facing position, you will know your seat is secure in position after hearing a click. Remove the infant inserts after since you can only use them in rear-facing mode. Make sure that your infant seat is in the forward-facing position.

Next, unclip and place the tether in the forward-facing position of the seat. Remove the lower anchor connectors from the storage area of the car seat base. Extend anchor strap to its maximum length. Route the anchor strap through the forward-facing belt path. Recline the car seat using the actuator to one of the four forward-facing positions. Place car seat in the back seat of your vehicle. Next, route the tether strap underneath the car headrest. Raise the headrest to the highest position then undo the snaps on the seat pad. Open the SnugLock lock off with the grey lever. Route your LATCH strap behind the SnugLock lock off. Attach lower anchor connectors to lower anchors in vehicle. After removing slack and closing the Snuglock lock-off, snap the seat pad back and lower the head rest.

Want to learn more about the Graco Turn2Me 3-in-1 Car Seat? Visit us: https://www.gracobaby.com/car-seats/t...

Want to learn about Graco’s car seat safety standards? Visit us: https://www.gracobaby.com/safety.html

#carseatinstallation
#convertiblecarseat
#bestinfantcarseat
#gracocarseat