Help control the spread of germs in the bathroom with the Cadet Touchless Toilet from American Standard. Simply position your hand in front of the sensor to trigger the powerful Cadet flush, an all-time, American Standard favorite for its proven ability to clear the bowl quickly and completely. Equipped with reliable touchless technology, a dependable flushing system, and a push-button actuator to enable a manual flush for uninterrupted operation, the Cadet Touchless Toilet is engineered to outperform and ensure a cleaner, more hygienic bathroom environment. To install your American Standard Touchless Toilet, there are 3 parts to this installation:
1. Installing the toilet bowl
2. Attaching the toilet tank
3. Connecting the sensor
The toilet parts included with your American Standard Touchless Toilet are as follows:
1. Bowl
2. Seat
3. Attachment Tool
4. Batteries
5. Sensor
6. Control Module
7. Hardware
8. Gasket
9. Tank
10. Tank Lid
For Part 1 of the installation, Installing the Toilet Bowl, follow these steps:
1. Shut off the water supply line and remove the old toilet
2. Clean the wax from the flange area as best you can. Make sure there is no debris in the hole
3. Secure the floor bolts to keep them upright
4. Press the wax ring firmly onto the tank
5. Use tape to help align the bowl with the floor bolts (optional)
6. Place the bowl over the floor bolts. Apply the weight evenly.
7. Secure bowl to the floor using the plastic wingnuts. Hand tighten (no tools required)
8. Apply the cap to cover the bolts.
9. Remove the optional placement tape from the floor
For Part 2 of the installation, Attaching the Toilet Tank, follow these steps:
1. Slide the gasket onto the toilet tank
2. Connect the water supply line to the valve and hand tighten. Then align the tank on top of the bowl
3. Attach plastic washers and nuts to the bolts on the tank
4. Use the attachment tool provided to secure nuts in place. Do not overtighten
For Part 3 of the installation, Connecting the Sensor, follow these steps:
1. Inside the tank, place the control module bracket over the flush valve in filter line
2. Use a Phillips screwdriver to open control module housing
3. Install the supplied 4 AA batteries in the waterproof control module housing
4. Be sure to install batteries in the correct direction and orientation
5. Assemble control module and place it in the bracket
6. Connect the control module wire with the wire from the flush valve
7. Open the sensor module by removing the two screws
8. Remove the back plate to access battery component, taking care not to undo the O-ring
9. Install the 3 AAA batteries
10. Reassemble the waterproof sensor module housing. Tighten the screws
11. Place the tank cover on the toilet
12. Mount the sensor within 3 feet of the toilet using the adhesive backed tape
13. The mounting base can also be secured to wall using supplied screws
14. Attach the sensor module to the base using quarter turn tabs
15. Turn on the water supply and flush test the toilet
16. Install the seat. Instructions are packaged with the seat

To learn more about the American Standard Touchless Toilet, visit https://www.americanstandard-us.com/b...