This is just a great project for anyone from a beginner in Nerf modding to someone with their first 3D printer. For around $15 dollars in materials and file fees, you have a cool custom blaster. And honestly it’s great for all of the experienced people too. Good design is always fun. Despite being a single shot plinker (It’s a Jolt reskin bro), I guarantee you’ll have fun with it, and as always, half the fun is picking out the colours you’ll print. I print with a P1P, so parts always look so good. None of these parts require supports either, so, very easy. Thanks again Domochevsky, you are the best. (And if you are reading this, I bought the files, no bias here.

X-Shot Micro Reshell 1
https://www.etsy.com/listing/15952307...

Check out all of the cool creations from GenCoMegawerks
https://www.etsy.com/shop/gencomegawe...

Follow Domochevsky on Instagram
  / otherchevsky  

Buy an X-Shot Micro
https://www.toysrus.ca/en/X-Shot-Exce...

00:00 Introduction and Chronograph
02:01 Disassembly
03:36 The 3D printed parts
04:23 Assembly
05:06 Remove dart post for short darts
08:38 The end