New Steam Boiler with Mill Steam Engine "Combination"
Ross 206 948 0770 *Watch video*
I AM NOW OFFERING 1/2 OFF ON SHIPPING!
This is my next fire-tube boiler with my newest Mill Steam Engine. It includes a brand new style of firebox with the ash pan. It is brand new and weighs around 525 lbs. It measures " 78 high to the top of the stack. 24" square at the base. The boiler itself is 20" dia. x 32" tall, made of 3/8" steel. The pop-off valve is set at 70 lbs. The boiler has 22 1-1/2" dia. copper tubes rolled in that are 28" long. The firebox is 24" x 24" x 15" tall with plenty of room for large pieces of wood or lots of coal. The ash pan is below the base. A feature on this boiler is the the blower ring. With the addition of this item, the draft is increased by ten times. The amount of air moving through the fire is amazing. It also includes a high pressure water pump for the boiler.
With this boiler is my fully machined and assembled Mill steam engine from castings including cross slide, flywheel, eccentric, piston and rings, and all moving parts for the engine. The bore is 3.00 inches with a 4.00 inch stroke. The overall length of the wood base is 36" the width of the engine is 18" and the height 28 inches. The flywheel is 12" dia. It weighs 150 lbs. I estimate the hp at 3 to 5 depending on boiler pressure. The lubricator and valves are included. It runs at 375 rpm wide open.
I do pressure test each boiler I have built to 250 lbs. and have sold over 150 boilers with no problems. I have been a welder for 48 years. They are all equipped with steam pressure relief valves. I can install valves to go off at 90 to 150 lbs.
I have owned 3 one hundred year old antique boilers. They all were built with 1/4" steel. My boilers are constructed with 3/8"steel and have copper tubes rolled in. They are built to last over 100 years. They will outlast the owners life time!
*Shipping is easy* I AM NOW OFFERING 1/2 OFF ON SHIPPING!