Today's episode of Harrison's Garage is a big one! In the last episode I put on 35" Toyo Tires on 17 KMC wheels. To help the wife get into her new ride I needed to put steps on and fast. We settled on the Rock Slide Engineering Gen 3 Step Sliders. They went on relatively as expected with a few issues toward the end. As always hit me up with questions in the comments below or DM me on Instagram @harrisons.garage.

Intro 0:12
Removing the fuse and disconnecting the battery 2:02
Feeding the wiring harness to the engine 3:38
Removing the door trim 6:33
Installing the door sensor 10:31
Installing the override switch 12:19
Fitment issues 16:29
Dremel the bracket nuts 17:28
Backing out the body bolts 19:35
Aligning the step's protective strip 22:33
Drilling out the pinch weld holes 26:43
Cutting the step to fit the 4xe bracket 27:42

Disclaimer: Due to factors beyond the control of Harrison's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Harrison's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Harrison's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Harrison's Garage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Harrison's Garage.