This is a guide for the DIY Modding Kit for Guitar Hero Controllers, available here:
https://www.etsy.com/listing/14071387...

I use the kit on a Kramer, but the process is very similar on other models. Please note that the Wii Les Paul and Xplorer require fret/neck modification to work properly.

Programming and configuration is made possible by the free and open source Santroller platform by Sanjay900; please sponsor or donate to Sanjay900 if you have the means, the entire plastic instrument modding scene would not be possible without his amazing software!

https://github.com/Santroller/Santroller

This kit assumes you have basic soldering experience and equipment, as well as some basic tinkering tools, such as a screwdriver and bit kit, flush cutters, tape, etc. Below are some affiliate links to tools you will need (I will get a small commission if you used the links below):

Soldering (what I use/have used):
Basic Soldering Station: https://amzn.to/3IQh3Qz
Soldering Fume Extractor: https://amzn.to/3EYLcw5
Amtech Flux: https://amzn.to/3EYLcw5
Kester Solder: https://amzn.to/3EXsuEN
Kapton Tape: https://amzn.to/3Jc1m7A
Perfboard for Soldering Practice: https://amzn.to/3yb02f9
Additional Soldering Tips: https://amzn.to/3KTDas5
Silicone Mat: https://amzn.to/41GCr3v

General Tools:
Flush Cutters: https://amzn.to/3mqcc15
Cheap Wire Cutters: https://amzn.to/3KWT6JS
Pro Wire Cutters: https://amzn.to/3kJcVtM
Security Bit Screwdriver set: https://amzn.to/3kPg8b8
Hot Glue Kit: https://amzn.to/3YpaI4l